目前處理的方式大多在漏電保護檢測回路并聯高壓電容，消除檢測信號中的高次諧波“毛刺”；其次可以利用優化漏電保護參數的方式，根據30mAS(毫安秒)原則，減小漏電電流，放大漏電保護時間，使其乘積保持不變。另外，變頻器跳饋電漏電保護，雖然與變頻器的電源特性有關，但是與饋電開關也有關系，不同廠家饋電開關的保護整定不同，要認真學習說明書。有時候，饋電開關的保護插件出現問題，也會造成饋電跳閘，這時候往往用戶會拿我們變頻器說事，所以一定要認真檢查，分析原因，正確處理。

對于風機水泵類負載，按照電動機的額(e)(e)定電壓/額(e)(e)定電流/額(e)(e)定功率，選用合適的變頻器。對于皮帶機等恒功率負載，要根據負載工況，選用與其工作特性相適應的變頻器，如下運皮帶機或者提升運輸絞車，選用四象限特性的變頻器，變頻器的功率應參考電動機的額(e)(e)定電流進行選擇，并大于電動機一個等級，以滿足重載起動的要求。

對于深井泵(潛水泵)負載，不同于一般的水泵負載，由于變頻器到電動機的距離較遠，需要增加輸出正弦波濾波器，改善輸出電壓和電流波形，增加驅動性能;變頻器驅動水泵負載時，由于排水泵為立方特性負載，即轉速越高阻力越大，所以變頻器的啟動時間不要太長，否則水泵會由于不能形成真空而不上水;調試中還要注意水泵的“水錘效應”，否則損壞管路，嚴重時釀成事故。